It has been a while since I did it, but I think it went like this. To display information about all paths, run the following command: The logs point to failures in the ssproxy. Reboot your system to remove the DSM. Enter the email address you signed up with and we'll email you a reset link.
| Uploader: | Mikaktilar |
| Date Added: | 18 November 2008 |
| File Size: | 37.24 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 25831 |
| Price: | Free* [*Free Regsitration Required] |
Because multiple software versions, product models, and operating system versions are all covered by the same jpio, you might find occasional differences between product directories and product names or model numbers shown here and what you see on your computer.
Best of luck Derrick. The failback feature is only valid when the load balance mode is FailOver.
HP MSA 2000 series MPIO DSM on Windows 2008
The information and instructions in this document also apply to versions prior to 2. So use with the P G3 is out of the question really. Microsoft Windows Server The logs point to failures in the ssproxy. It also enables you to specify which commands the DSM is to use.
In these configurations, dwm to remove the old DSM could cause the system to become unbootable. Shut down the host. They're replicating now somewhere in India, and fair play to them, I think we'll get somewhere.
HP StorageWorks MSA System MPIO DSM Installation Guide_百度文库
You're using an out-of-date version of Internet Explorer. But I'll post my results as soon as I have them And, dm for the confusion - yes my system is two blades trying to connect to the storage using Cluster Shared Volumes - the same kit and setup works fine for Windows R2 - and my fall back position is to install WR2 on these two blades and leave it for someone else when I'm outta here!
Review the information on the download page and on the Installation Instructions and Release Notes tabs before downloading and installing vor software. The web page is so slow for volume mapping that I used the CLI instead. The time it takes to complete MPIO DSM installation, initial scan, and detection of devices depends on the complexity of the system configuration, the number of LUNs, and the number of devices connected to the host.
HP StorageWorks P/MSA MPIO DSM Release Notes
There is a single active path and the rest of the paths are standby paths. Reboot your system to remove the DSM.
Using the dsmcli Command-Line Utility The DSM command-line interface enables you to display or change devices, paths, and load balance policies, and enables you to diagnose and troubleshoot the DSM. To install this component: Hope that explains it a bit more HA shoud work witout storage spaceas they are p22000/msa2000 drives that shoud see each other perfectly.
Although it is not necessary to disconnect the storage array from the host while uninstalling and installing the MPIO DSM, depending on the number of paths and LUNs in the configuration, the process may complete significantly faster with the array disconnected. I'll try to do single path later this evening, in order to answer your windoss, but I doubt it working.
Nothing herein should be construed as constituting an additional warranty.
Sorry if this runs all into one line To see the current mappings show host-wwn-names: Will keep checking on here for any updates. I can on Windows R2 - very easily.
Consistent with FAR If the path with the lowest weight fails, then the path with the next lowest weight is used. Installing on Windows Server R2 Microsoft has deprecated the servermanagercmd command for Windows Server R2, so use the ocsetup command instead. The blue screen only happens if two servers try to connect to the same LUN at the same time, which is what it was supposed to be able to do - c. Example In the following example, before executing the command, primaryPrimary is shown as false; after running the command, Primary is shown as true.
No comments:
Post a Comment